P0710

P0710 A/T FLUID TEMPERATURE SENSOR





Description
The A/T fluid temperature sensor detects the A/T fluid temperature and transmits a signal to the TCM.




DTC Logic

DTC DETECTION LOGIC

DTC Detection Logic:

DTC CONFIRMATION PROCEDURE

CAUTION:
Always drive vehicle at a safe speed.
1.PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
- GO TO 2.
2.CHECK DTC DETECTION
With CONSULT-III
1. Start the engine.
2. Select "SLCT LVR POSI" and "VHCL/S SE-A/T" with "Data Monitor".
3. Drive vehicle and maintain the following conditions for 14 minutes or more.

SLCT LVR POSI : D
VHCL/S SE-A/T : 10 km/h (7 MPH) or more

4. Perform "Self Diagnostic Results" mode for "TRANSMISSION".
With GST
Follow the procedure "With CONSULT-III".
Is "P0710" detected?
YES - Go to P0710.
NO - INSPECTION END




Diagnosis Procedure
1.CHECK INTERMITTENT INCIDENT
Refer to Intermittent Incident.
Is the inspection result normal?
YES - Replace A/T assembly. Refer to Exploded View.
NO - Repair or replace damaged parts.