P0607

DTC P0607 ECM





Description
CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN H line, CAN L line) allowing a high rate of information transmission with less wiring.
Each control unit transmits/receives data but selectively reads required data only.




On Board Diagnosis Logic
This self-diagnosis has the one trip detection logic.

On Board Diagnosis Logic:

DTC Confirmation Procedure
1. Turn ignition switch ON.
2. Check DTC.
3. If DTC is detected, go to P0607.




Diagnosis Procedure
1.INSPECTION START
1. Turn ignition switch ON.
2. Erase DTC.
3. Perform DTC Confirmation Procedure.
See P0607.
4. Check DTC.
5. Is DTC P0607 displayed again?
Yes or No
Yes - GO TO 2.
No INSPECTION END
2.REPLACE ECM
1. Replace ECM.
2. Perform initialization of IVIS (NATS) system and registration of all IVIS (NATS) ignition key IDs. Refer to Programming and Relearning.
3. Perform Testing and Inspection.
4. Perform Testing and Inspection.
5. Perform Throttle Valve Closed Position Learning.
6. Perform Testing and Inspection.
INSPECTION END