P1715

DTC P1715 INPUT SPEED SENSOR





Description
ECM receives input speed sensor signal from TCM via the CAN communication line. ECM uses this signal for engine control.




CONSULT-III Reference Value in Data Monitor Mode
Specification data are reference values.









On Board Diagnosis Logic

NOTE:
- If DTC P1715 is displayed with DTC UXXXX, first perform the trouble diagnosis for DTC UXXXX.
- If DTC P1715 is displayed with DTC P0335, first perform the trouble diagnosis for DTC P0335. Refer to P0335.
- If DTC P1715 is displayed with DTC P0340, first perform the trouble diagnosis for DTC P0340. Refer to P0340.
- If DTC P1715 is displayed with DTC P0605, first perform the trouble diagnosis for DTC P0605. Refer to P0605.
- If DTC P1715 is displayed with DTC P0607, first perform the trouble diagnosis for DTC P0607. Refer to P0607.
The MIL will not illuminate for this diagnosis.

On Board Diagnosis Logic:

Diagnosis Procedure
1.CHECK DTC WITH TCM
Check DTC with TCM. Refer to OBD-II Diagnostic Trouble Code (DTC).
OK or NG
OK - GO TO 2.
NG - Perform trouble shooting relevant to DTC indicated.
2.REPLACE TCM
Replace TCM.
INSPECTION END