Ignition Coil: Service and Repair

Ignition Coil Replacement

Removal Procedure






1. Disconnect the ignition coil wiring harness electrical connector (1) from the ignition coil.






2. Remove the spark plug wire from the ignition coil.
- Twist the spark plug wire boot a 1/2 turn.
- Pull only on the boot in order to remove the wire from the ignition coil.

3. Remove the ignition coil bolts.
4. Remove the ignition coil from the bracket. (left side shown, right side similar).

Installation Procedure






1. Position the ignition coil to the ignition coil bracket. (left side shown, right side similar).

NOTICE: Fastener Notice

2. Install the ignition coil bolts.

Tighten
Tighten the stud to 8 N.m (71 lb in)

3. Install the spark plug wire to the ignition coil.
4. Inspect the spark plug wire for proper installation:
- Push sideways on each boot in order to inspect the seating.
- Reinstall any loose boot.






5. Connect the ignition coil wiring harness electrical connector (1) to the ignition coil.