Input Shaft Disassembly

^ Tools Required:
- J 22912-01 Split Plate
- Or Equivalent

DISASSEMBLE








1. Pull out the rear bearing, 4th gear, 3rd/4th synchronizer assembly, and 3rd gear all together, using J 22912-01 (inverted) and a press.

Important: Heat the input shaft, collar and stopper plate in an approved preheat oven to approximately 95° C (200° F) just prior to removal. DO NOT use an acetylene torch or other open flame. Always allow preheated parts to cool after removal. DO NOT quench preheated parts with water. Use compressed air to help in cooling any preheated parts.

CAUTION: When handling parts that have been preheated for installation purposes, always wear leather welding gloves with a minimum amount of handling time. If this precaution is not observed, severe skin burns or personal injury may result.

2. Collar and stopper plate using a split plate (inverted) with a press and discard the collar and stopper plate.