Do you have access to Mitchell1 Prodemand? If you are willing to share user/password (we can pay $250), please get in contact with us ASAP: email operation-charm [[at]] tuta.io or click to submit anonymously
Rear Brake Caliper and Disc Rotor
Rear Brake Caliper and Disc Rotor: Removal and Installation
NOTE:
When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spilling.
Removal
1) Remove the rear wheel and tire. Refer to [Tire Rotation] Service and Repair.
2) Remove the union bolt (A) then disconnect the brake hose and discard the copper sealing washers.
CAUTION:
Do not reuse copper sealing washers.
3) Remove the sliding pin bolts (A) and remove the caliper body from torque member.
4) Remove the brake pads, shims and retainers from the torque member.
5) Remove the torque member bolts and remove the torque member.
6) Remove the disc rotor. If reusing the disc rotor, apply a matching mark (A) as shown for installation.
CAUTION:
Put matching marks on the wheel hub assembly and disc rotor, if reusing the disc rotor.
Installation
1) Install the disc rotor. If reusing the disc rotor, align the matching marks (A) as shown for installation.
CAUTION:
Align the matching marks on the wheel hub assembly and disc rotor, if reusing the disc rotor.
2) Install torque member and tighten the torque member bolts to specification. Refer to [Rear Brake Caliper: Exploded View [On-Vehicle Repair] Rear Brake Caliper Exploded View [On-Vehicle Repair] ].
3) Install the brake pads, shims and retainers on the torque member. Refer to [Rear Brake Pad: Exploded View] Rear Brake Pad Exploded View.
4) Install caliper body and sliding pins, then tighten the sliding pin bolts (A) to the specified torque. Refer to [Rear Brake Caliper: Exploded View [On-Vehicle Repair] Rear Brake Caliper Exploded View [On-Vehicle Repair] ].
CAUTION:
When installing the caliper body to the torque member, wipe any oil off of the washers and caliper body attachment surfaces.
5) Install brake hose by aligning with the protrusion on caliper body, then install new copper sealing washers (1) and union bolt (A). Tighten union bolt (A) to specified torque. Refer to [Brake Tube and Hose: Hydraulic Circuit] [1][2]Diagrams.
CAUTION:
Do not reuse copper sealing washers.
6) Refill with new brake fluid as necessary and bleed the brake system. Refer to [Brake Fluid: Bleeding Brake System] Service and Repair.
CAUTION:
- Refill with new brake fluid.
- Do not reuse drained brake fluid.
7) Install the rear wheel and tire. Refer to [Tire Rotation] Service and Repair.