Installation

2TR-FE ENGINE MECHANICAL: ENGINE FRONT OIL SEAL: INSTALLATION

INSTALLATION





1. INSTALL TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL
(a) Apply a light coat of MP grease to the lip of a new oil seal.
NOTICE: Keep the lip free of foreign objects.

(b) Using SST, uniformly tap a new oil seal in until its surface is flush with the timing chain cover edge.
SST: 09223-50010

NOTE:
- Do not tap the oil seal in at an angle.
- Wipe any extra grease off the crankshaft.

2. INSTALL CRANKSHAFT PULLEY





(a) Align the set key of the crankshaft with the key groove of the pulley, and slide on the pulley.
(b) Provisionally install a new crankshaft pulley bolt onto the crankshaft.
(c) Using SST, hold the crankshaft pulley and tighten the crankshaft pulley bolt.
SST: 09213-54015
91651-60855
SST: 09330-00021
Torque: 260 Nm (2,651 kgf-cm, 192 ft-lbf)
NOTICE: Do not reuse the pulley bolt.





(d) Install the bracket with the bolt. (w/ AIR CONDITIONING)
Torque: 7.5 Nm (76 kgf-cm, 66 in-lbf)
3. INSTALL FAN SHROUD Installation
4. INSTALL RADIATOR SUPPORT TO FRAME SEAL LH Installation
5. ADD ENGINE COOLANT Service and Repair
6. CHECK FOR ENGINE COOLANT LEAKAGE Testing and Inspection
7. CHECK FOR ENGINE OIL LEAKAGE
8. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (for Pre Runner and 4WD Type)
(a) Install the No. 1 engine under cover with the 4 bolts.
Torque: 30 Nm (306 kgf-cm, 22 ft-lbf)