Removal

2TR-FE ENGINE CONTROL SYSTEM: THROTTLE BODY: REMOVAL

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (for 4WD and Pre-Runner)
3. DRAIN ENGINE COOLANT Service and Repair
4. REMOVE INTAKE AIR CONNECTOR





(a) Disconnect the pressure sensor connector.
(b) Disengage the wire harness clamp.
(c) Disconnect the vacuum hose.





(d) Disconnect the No. 2 ventilation hose.





(e) Disconnect the vacuum hose.





(f) Loosen the 2 hose clamp bolts.
(g) Remove the 3 bolts, then remove the intake air connector.
5. REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY





(a) Disconnect the water by-pass hose.
(b) Disconnect the No. 2 water by-pass hose.
(c) Disconnect the throttle motor connector.





(d) Remove the 2 bolts and 2 nuts, then remove the throttle with motor body.





(e) Remove the gasket from the intake manifold.