Installation

WIPER / WASHER: REAR WIPER MOTOR: INSTALLATION

1. INSTALL REAR WIPER MOTOR AND BRACKET ASSEMBLY

(a) Attach the 2 guides and temporally install the rear wiper motor and bracket assembly with the 3 bolts.





(b) Tighten the 3 bolts.

Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)

(c) Connect the connector.

2. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY

(a) Clean the wiper arm serrations.









(b) Clean the wiper pivot serrations with a wire brush.









(c) Operate the rear wiper and stop the rear wiper motor at the automatic stop position.

HINT
The wiper motor does not operate if the back door and back door glass are not closed.

(d) With the rear wiper blade and linear wiper step in the positions shown in the illustration, install the rear wiper blade assembly with the nut.





Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)





HINT
Hold the arm hinge down by hand while tightening the nut.

(e) Place the rear wiper blade assembly in the automatic stop position.









3. INSTALL REAR SPOILER SUB-ASSEMBLY Installation

4. INSTALL REAR NO. 1 SPOILER COVER Installation

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.