Installation

EXTERIOR PANELS / TRIM: FRONT BUMPER: INSTALLATION

HINT
A bolt without a torque specification is shown in the standard bolt chart Standard Bolt - Specified Torque For Standard Bolts.

1. INSTALL FRONT UPPER CENTER BUMPER RETAINER





(a) Install the bumper retainer with the 3 bolts.

2. INSTALL HEADLIGHT ASSEMBLY LH Installation

3. INSTALL HEADLIGHT ASSEMBLY RH

HINT
Use the same procedures described for the LH side.

4. INSTALL FRONT BUMPER SIDE SUPPORT LH





(a) Attach the 3 clips to install the side support.

(b) Install the 2 screws.

5. INSTALL FRONT BUMPER SIDE SUPPORT RH

HINT
Use the same procedures described for the LH side.

6. INSTALL FRONT NO. 2 BUMPER EXTENSION SUB-ASSEMBLY LH





(a) Install the bumper extension with the 4 nuts.

Torque : 67 Nm (683 kgf-cm, 49 ft-lbf)

7. INSTALL FRONT NO. 2 BUMPER EXTENSION SUB-ASSEMBLY RH

HINT
Use the same procedures described for the LH side.

8. INSTALL FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY





(a) Install the reinforcement with the 6 nuts.

Torque : 71 Nm (724 kgf-cm, 52 ft-lbf)

9. INSTALL FRONT BUMPER ENERGY ABSORBER





(a) Install the energy absorber.

10. INSTALL FRONT BUMPER COVER





(a) w/ Headlight Cleaner System:

Connect the headlight cleaner hose.

(b) Connect the No. 4 engine room wire and attach the 10 claws to install the bumper cover.

(c) Install the 3 clips, 4 screws and 4 bolts.





(d) Using a T30 "TORX" socket, install the 6 screws.





11. INSTALL RADIATOR GRILLE ASSEMBLY Installation

12. INSTALL UPPER RADIATOR SUPPORT SEAL Installation

13. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH





(a) Push in the clip indicated by the arrow in the illustration to install the fender splash shield.

(b) Install the 3 bolts and screw.

14. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

HINT
Use the same procedures described for the LH side.