Installation

SEAT: FRONT SEAT ASSEMBLY (for Manual Seat): INSTALLATION

HINT
* Use the same procedures for the RH side and LH side.
* The procedures listed below are for the LH side.
1. INSTALL FRONT SEAT ASSEMBLY

(a) Place the seat in the cabin.

NOTICE:
Be careful not to damage the vehicle body.

(b) Connect the connector under the seat.

(c) Lift up the seat track adjusting handle and move the seat to the rearmost position.

(d) Install the 2 bolts to the front side of the seat.





Torque : 37 Nm (377 kgf-cm, 27 ft-lbf)

HINT
Tighten the bolts in the order indicated in the illustration.

(e) Lift up the seat track adjusting handle and move the seat to the foremost position.

(f) Install the 2 bolts to the rear side of the seat.





Torque : 37 Nm (377 kgf-cm, 27 ft-lbf)

HINT
Tighten the bolts in the order indicated in the illustration.

2. INSPECT AND ADJUST SEAT SLIDE ADJUSTER LOCKS

(a) During sliding operation of the front seat, check that the left and right adjusters move together smoothly and lock simultaneously.

If the seat adjusters do not lock simultaneously, loosen the seat fixation bolts to adjust the adjuster's position.

3. INSTALL FRONT SEAT TRACK BRACKET OUTER COVER LH

(a) Install the outer cover in the direction indicated by the arrow in the illustration and attach the 2 claws.





4. INSTALL FRONT SEAT TRACK BRACKET INNER COVER LH

(a) Install the inner cover in the direction indicated by the arrow in the illustration and attach the 2 claws.





5. INSTALL FRONT SEAT HEADREST ASSEMBLY

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

7. CHECK SRS WARNING LIGHT (w/ Front Seat Side Airbag)

(a) Check the SRS warning light Diagnosis System.

8. INSPECT FRONT SEAT ASSEMBLY

(a) for Front Passenger Side:

Perform the zero point calibration and sensitivity check Programming and Relearning.