Installation

AIR CONDITIONING: CONDENSER: INSTALLATION

1. INSTALL COOLER DRYER

(a) Using pliers, install the cooler dryer.

(b) Apply a sufficient amount of compressor oil to the contact surfaces of a new O-ring and the cap.

Compressor oil:

ND-OIL 8 or equivalent

Torque : 2.9 Nm (29 kgf-cm, 25 in-lbf)

2. INSTALL COOLER CONDENSER ASSEMBLY

(a) Install the cooler condenser.

3. INSTALL NO. 2 FAN SHROUD

(a) Install the fan shroud with the 2 bolts.

Torque : 10.5 Nm (107 kgf-cm, 8 ft-lbf)

4. INSTALL RADIATOR SUPPORT UPPER BRACKET

(a) Install the 2 brackets with the 2 bolts.

Torque : 45 Nm (459 kgf-cm, 33 ft-lbf)

HINT
If the condenser is replaced with a new one, add compressor oil to the new condenser.

Capacity:

40 cc (1.4 fl. oz.)

Compressor oil:

ND-8 or equivalent

5. INSTALL COOLER REFRIGERANT LIQUID PIPE

(a) Remove the attached vinyl tape from the pipe and the connecting part of the cooler condenser.

(b) Sufficiently apply compressor oil to a new O-ring and the fitting surface of the pipe joint.

Compressor oil:

ND-OIL 8 or equivalent

(c) Install the O-ring on the cooler refrigerant liquid pipe.

(d) Install the cooler refrigerant liquid pipe on the cooler condenser with the bolt.

Torque : 9.8 Nm (100 kgf-cm, 7 ft-lbf)

6. INSTALL NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

(a) Remove the attached vinyl tape from the hose and the connecting part of the cooler condenser.

(b) Sufficiently apply compressor oil to a new O-ring and the fitting surface of the hose joint.

Compressor oil:

ND-OIL 8 or equivalent

(c) Install the O-ring on the cooler refrigerant discharge hose.

(d) Install the cooler refrigerant discharge hose on the cooler condenser with the bolt.

Torque : 9.8 Nm (100 kgf-cm, 7 ft-lbf)

7. ADJUST HOOD SUB-ASSEMBLY Adjustments

8. INSTALL FRONT BUMPER COVER

(a) Install the front bumper cover Installation.

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

10. CHARGE REFRIGERANT Service and Repair

11. WARM UP ENGINE Service and Repair

12. INSPECT FOR REFRIGERANT LEAK Service and Repair