Removal

DOOR LOCK: DOOR CONTROL RECEIVER: REMOVAL

1. REMOVE REAR DOOR SCUFF PLATE RH





(a) Using a screwdriver, detach the 9 claws.

HINT
Tape the screwdriver tip before use.

(b) Using a clip remover, detach the 2 clips and remove the garnish.

2. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH

3. REMOVE REAR FLOOR NO. 1 BOARD (w/o Rear No. 2 Seat)

4. REMOVE DECK BOARD ASSEMBLY (w/o Rear No. 2 Seat)

5. REMOVE NO. 2 SEAT HINGE COVER LH (w/ Rear No. 2 Seat) Removal

6. REMOVE NO. 2 SEAT HINGE COVER RH (w/ Rear No. 2 Seat)

HINT
Use the same procedures described for the LH side.

7. REMOVE NO. 2 SEAT LEG COVER LH (w/ Rear No. 2 Seat) Removal

8. REMOVE NO. 2 SEAT LEG COVER RH (w/ Rear No. 2 Seat)

HINT
Use the same procedures described for the LH side.

9. REMOVE REAR NO. 2 SEAT ASSEMBLY LH (w/ Rear No. 2 Seat) Removal

10. REMOVE REAR NO. 2 SEAT ASSEMBLY RH (w/ Rear No. 2 Seat)

11. REMOVE REAR FLOOR NO. 3 BOARD

12. REMOVE REAR FLOOR NO. 2 BOARD

13. REMOVE REAR FLOOR NO. 1 MAT SUPPORT SIDE PLATE Removal

14. REMOVE REAR FLOOR FINISH PLATE Removal

15. REMOVE REAR DECK TRIM COVER RH (w/ Rear No. 2 Seat)

(a) Remove the bolt.

(b) Using a screwdriver, detach the 4 claws and remove the trim cover.

HINT
Tape the screwdriver tip before use.

16. REMOVE RECLINING REMOTE CONTROL LEVER BEZEL RH (w/o Rear No. 2 Seat) Removal

17. REMOVE TETHER ANCHOR BRACKET SUB-ASSEMBLY (w/o Rear No. 2 Seat)





(a) Remove the bolt and tether anchor bracket.

18. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH (w/o Rear No. 2 Seat) Removal

19. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH (w/ Rear No. 2 Seat) Removal

20. REMOVE INNER ROOF SIDE GARNISH ASSEMBLY RH (w/o Rear No. 2 Seat)





(a) Using a clip remover, detach the 7 clips and remove the garnish.

21. REMOVE INNER ROOF SIDE GARNISH ASSEMBLY RH (w/ Rear No. 2 Seat)





(a) Disconnect the rear No. 2 seat outer belt's shoulder anchor.

(1) Using a screwdriver, detach the 2 claws and open the seat belt anchor cover.

HINT
Tape the screwdriver tip before use.

(2) Remove the bolt and disconnect the shoulder anchor.





(b) Using a clip remover, detach the 7 clips and remove the garnish.

22. REMOVE DOOR CONTROL RECEIVER





(a) Disconnect the receiver connector.

(b) Remove the bolt and receiver.