C1625

PARK ASSIST / MONITORING: ADVANCED PARKING GUIDANCE SYSTEM: C1625: Open or Short in Steering Angle Sensor +B
C1625 - Open or Short in Steering Angle Sensor +B

DESCRIPTION

This DTC is stored if the parking assist ECU receives a signal via CAN communication from the spiral with sensor cable sub-assembly that indicates a power supply system problem.





WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
* When "System initializing" message is displayed on the navigation receiver assembly after the battery terminal disconnected, correct the steering angle neutral point Initialization.
* Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the advanced parking guidance system may be needed Calibration.

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY POWER SUPPLY)

(a) Disconnect the L51 connector from the spiral with sensor cable sub-assembly.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





(c) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY Removal