Removal

2ZR-FXE EMISSION CONTROL: CANISTER: REMOVAL

1. REMOVE REAR NO. 2 FLOOR BOARD (for Separate Type) Removal

2. REMOVE REAR DECK FLOOR BOX Removal

3. REMOVE REAR NO. 3 FLOOR BOARD Removal

4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

5. REMOVE REAR FLOOR STEP UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)

(a) Remove the 5 clips (A) and nut.





(b) Disconnect the 3 clips (B) and remove the rear floor step under cover sub-assembly.

6. REMOVE CHARCOAL CANISTER ASSEMBLY

(a) Using a screwdriver, pry up the retainer.





HINT
Do not remove the retainer.

(b) Disconnect the tube clamp, purge line hose and vent line tube.

NOTICE:
* Remove any dirt or foreign matter on the vent line tube connector before performing this work.









* Do not allow any scratches or foreign matter on the parts when disconnecting them as the vent line tube connector has an O-ring that seals the pipe.
* Perform this work by hand. Do not use any tools.
* Do not forcibly bend, twist or turn the nylon tube.
* Protect the disconnected part by covering it with a plastic bag after disconnecting the vent line tube.
* If the vent line tube connector and pipe are stuck, push and pull to release them.
(c) Disconnect the tube clamp, wire harness clamp and connector air inlet line tube.





(d) Remove the 3 bolts, clip and charcoal canister assembly.