Removal

SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system Service Precautions.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE FRONT DOOR SCUFF PLATE Removal

3. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

(a) Remove the rear part of the front door opening trim weatherstrip to the extent that allows removal of the lower center pillar garnish and center pillar garnish.





4. REMOVE REAR DOOR SCUFF PLATE Removal

5. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP

(a) Remove the front part of the rear door opening trim weatherstrip to the extent that allows removal of the lower center pillar garnish and center pillar garnish.





6. REMOVE LAP BELT OUTER ANCHOR COVER

(a) Disengage the 3 claws and remove the lap belt outer anchor cover.





7. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY

(a) Remove the bolt and disconnect the floor end of the front seat outer belt assembly.





8. REMOVE LOWER CENTER PILLAR GARNISH Removal

9. REMOVE UPPER CENTER PILLAR GARNISH Removal

10. REMOVE FRONT SEAT OUTER BELT ASSEMBLY

(a) Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.





(b) Using a screwdriver, pull out the locking button in the direction shown by the arrow to release the lock, and disconnect the pretensioner connector as shown in the illustration.





HINT
Tape the screwdriver tip before use.

(c) Remove the bolt.





(d) Disengage the 2 guides and remove the front seat outer belt assembly.

11. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

(a) Remove the 2 bolts.





(b) Disengage the guide and remove the front shoulder belt anchor adjuster assembly.