Installation

PARKING BRAKE: PARKING BRAKE PEDAL: INSTALLATION

1. INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY

(a) Install the parking brake control pedal assembly with the bolt and 2 nuts.

Torque : 15 Nm (148 kgf-cm, 11 ft-lbf)

(b) Connect the parking brake switch connector.

Torque : 15 Nm (148 kgf-cm, 11 ft-lbf)

(e) Engage the clamp.

(f) Temporarily install the lock nut.

Text in Illustration

HINT
After adjusting parking brake pedal travel, tighten the lock nut.

2. CONNECT NO. 1 PARKING BRAKE PULL ROD SUB-ASSEMBLY

(a) Connect the No. 1 parking brake pull rod sub-assembly to the parking brake control pedal assembly as shown in the illustration.

Text in Illustration

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

3. INSTALL NO. 3 BELT ANCHOR REINFORCEMENT SUB-ASSEMBLY

(a) Install the No. 3 belt anchor reinforcement sub-assembly with the 4 bolts.

Torque : 27 Nm (275 kgf-cm, 20 ft-lbf)

4. INSTALL NO. 2 BELT ANCHOR REINFORCEMENT SUB-ASSEMBLY

(a) Install the No. 2 belt anchor reinforcement sub-assembly with the 4 bolts.

Torque : 27 Nm (275 kgf-cm, 20 ft-lbf)

5. INSTALL FRONT SEAT ASSEMBLY LH

HINT
Refer to the instructions for Installation of the front seat assembly Installation.

6. INSTALL FRONT SEAT ASSEMBLY RH

HINT
Perform the same procedure as for the LH side.

7. INSTALL AIR CONDITIONING UNIT

HINT
Refer to the instructions for Installation of the air conditioning unit Installation.

8. ADJUST PARKING BRAKE PEDAL TRAVEL Adjustments

9. INSPECT BRAKE WARNING LIGHT Adjustments