Shift Cable: Adjustments

U760E AUTOMATIC TRANSMISSION / TRANSAXLE: TRANSMISSION CONTROL CABLE: ADJUSTMENT

1. INSPECT SHIFT LEVER POSITION

(a) When the shift lever is moved from P to R with the ignition switch ON and brake pedal depressed, make sure that the shift lever moves smoothly and correctly into the position.

(b) Start the engine and make sure that the vehicle moves forward when the shift lever is moved from N to D and moves rearward when the shift lever is moved to R.

2. ADJUST SHIFT LEVER POSITION

(a) Move the shift lever to N.

(b) Remove the rear console box assembly Removal.

(c) Disconnect the end of transmission control cable assembly from the lower shift lever assembly





(d) Slide the slider of the transmission control cable in the direction indicated by the arrow and pull the lock piece outward.





Text in Illustration





(e) Install the transmission control cable end to the shift lever assembly.





Text in Illustration





NOTICE:
* Check that the lock piece is pulled up.
* Install the cable end all the way to the base of the pin.

(f) Push the lock piece into the adjuster case.

NOTICE:
* Check that the park/neutral position switch and the shift lever are in neutral.
* Securely push in the lock piece until the slider lock is engaged.

(g) After adjusting the shift lever position, check the operation and function of the shift lever. If there is a problem, adjust the position again.

(h) Install the rear console box assembly Installation.