Installation
U760E AUTOMATIC TRANSMISSION / TRANSAXLE: SHIFT LEVER: INSTALLATION
1. INSTALL SHIFT LEVER SUPPORT
(a) Install the shift lever support with the 4 bolts in the sequence shown in the illustration.
Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)
2. INSTALL LOWER SHIFT LEVER ASSEMBLY
NOTICE:
Check that the park/neutral position switch and the shift lever are in neutral.
(a) Install the lower shift lever assembly with the 4 bolts in the sequence shown in the illustration.
Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)
(b) Connect the 3 clamps and 2 connectors.
(c) Slide the slider of the transmission control cable in the direction indicated by the arrow and pull the lock piece outward.
Text in Illustration
(d) Install the transmission control cable end to the lower shift lever assembly.
Text in Illustration
NOTICE:
* Check that the lock piece is pulled up.
* Install the cable end all the way to the base of the pin.
(e) Push the lock piece into the adjuster case.
NOTICE:
* Check that the park/neutral position switch and the shift lever are in neutral.
* Securely push in the lock piece until the slider lock is engaged.
3. INSTALL NO. 1 CONSOLE BOX DUCT (w/ Rear Register Duct)
(a) Install the clip and No. 1 console box duct.
4. INSTALL NO. 1 CONSOLE BOX MOUNTING BRACKET
(a) Install the No. 1 console box mounting bracket to the lower shift lever assembly with the screw.
5. INSTALL FLOOR CARPET BRACKET LH Installation
6. INSTALL CONSOLE BOX INSERT Installation
7. INSTALL FRONT NO. 2 CONSOLE BOX INSERT Installation
8. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY Installation
9. INSTALL BOX BOTTOM MAT Installation
10. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY Installation
11. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY Installation
12. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation
13. INSTALL INSTRUMENT SIDE PANEL RH Installation
14. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH Installation
15. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH Installation
16. INSTALL FRONT DOOR SCUFF PLATE RH Installation
17. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL ASSEMBLY Installation
18. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY Installation
19. INSTALL INSTRUMENT SIDE PANEL LH Installation
20. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH Installation
21. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH Installation
22. INSTALL FRONT DOOR SCUFF PLATE LH Installation
23. INSTALL CONSOLE BOX ASSEMBLY
Installation
24. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
25. INSPECT SHIFT LEVER POSITION
26. PERFORM DIAGNOSTIC SYSTEM CHECK
* for Built-in Type Yaw Rate Sensor: Built-in Type Yaw Rate Sensor
* for Separate Type Yaw Rate Sensor: Separate Type Yaw Rate Sensor
27. INSPECT SRS WARNING LIGHT
* for Built-in Type Yaw Rate Sensor: Built-in Type Yaw Rate Sensor
* for Separate Type Yaw Rate Sensor: Separate Type Yaw Rate Sensor