Removal

WINDOW / GLASS: POWER WINDOW REGULATOR MOTOR (for Rear Door): REMOVAL

HINT
* Use the same procedure for both the RH and LH sides.
* The procedure described below is for the LH side.

1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Service Precautions.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG Disassembly

4. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL Disassembly

5. REMOVE REAR ARMREST ASSEMBLY Disassembly

6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY Disassembly

7. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP Disassembly

8. REMOVE REAR DOOR SERVICE HOLE COVER Disassembly

9. DISCONNECT REAR DOOR WEATHERSTRIP

(a) Disconnect the upper part of rear door weatherstrip as shown in the illustration.





10. REMOVE REAR DOOR GLASS RUN Disassembly

11. REMOVE REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY Disassembly

12. REMOVE REAR DOOR QUARTER WINDOW GLASS

(a) Remove the rear door quarter window glass with the rear door quarter window weatherstrip as shown in the illustration.





13. REMOVE REAR DOOR GLASS SUB-ASSEMBLY Disassembly

14. REMOVE REAR DOOR WINDOW REGULATOR ASSEMBLY Disassembly

15. REMOVE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY Disassembly