Installation
SUPPLEMENTAL RESTRAINT SYSTEMS: KNEE AIRBAG ASSEMBLY: INSTALLATION
1. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
(a) Check that the power switch is off.
(b) Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
(c) Connect the airbag connector to the lower No. 1 instrument panel airbag assembly.
NOTICE:
When connecting any airbag connector, take care not to damage the airbag wire harness.
(d) Push in the lock to install the airbag connector.
Text in Illustration
(e) Install the clamp.
(f) Engage the 2 claws to install the DLC3.
(g) Engage the 6 claws, 3 guides and 2 hooks to temporarily install the lower No. 1 instrument panel airbag assembly.
Text in Illustration
(h) Install the 4 bolts.
Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)
NOTICE:
Confirm that the lower No. 1 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.
2. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation
3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Installation
4. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY Installation
5. INSTALL UPPER INSTRUMENT PANEL FINISH PANEL Installation
6. INSTALL INTEGRATION CONTROL AND PANEL Installation
7. INSTALL CONSOLE BOX ASSEMBLY
Installation
8. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
9. INSTALL DECK FLOOR BOX RH Installation
10. INSTALL REAR DECK FLOOR BOX Installation
11. INSTALL NO. 1 DECK BOARD Installation
12. INSTALL NO. 2 DECK BOARD Installation
13. INSTALL DECK BOARD ASSEMBLY Installation
14. PERFORM DIAGNOSTIC SYSTEM CHECK
Reading and Clearing Diagnostic Trouble Codes
15. INSPECT SRS WARNING LIGHT
Diagnosis System