Windshield and Headlamp Washer Fluid Reservoir

Windshield and Headlamp Washer Fluid Reservoir

• In order to prevent interchanging washer fluid line connections at Windshield and Rear Window Washer Pump (V59), connections at pump and hose lines are color-coded. Hose connector pieces must be connected to the corresponding colored pump connections during installation.

Removing

- Switch off ignition, switch off all electrical consumers and remove ignition key.

- Remove front right wheel housing liner.

- Remove mounting bolts - 2 - for tank - 1 - in wheel housing.





- Disconnect electrical multi-pin harness connector - 1 - of Windshield and Rear Window Washer Pump (V59).





- Remove windshield and headlamp washer system reservoir - 1 - back - arrow - from filler tube - 2 -.





- Place tank - 1 - on front tire.

- Unclip hose - 1 - from tank - arrows - and disconnect it from Headlamp Washer Pump (V11) - 2 -.





- Drain windshield and headlamp washer system reservoir and collect fluid.

- Disconnect multi-pin harness connector at Headlamp Washer Pump (V11) - 2 -.

- Disconnect multi-pin harness connectors at Windshield Washer Fluid Level Sensor (G33) - 1 - and at Windshield and Rear Window Washer Pump (V59) - 2 -.





- Release and disconnect angle connecting pieces - 3 - and - 4 - from Windshield and Rear Window Washer Pump (V59) - 2 -.

- Remove windshield and headlamp washer system reservoir from wheel housing.

Installing

Install in reverse order of removal, noting the following:

- Angled connecting pieces - 3 - and - 4 - are color-coded and must be allocated to the corresponding color connections of Windshield and Rear Window Washer Pump (V59) when installing.

- Bleed headlamp washer system after completing assembly work --> [ Headlamp Washer System, Bleeding ] Headlamp Washer System, Bleeding.