Generator with Torsion Elastic Clutch Overview
Generator with Torsion Elastic Clutch Overview
• Only generators by Hitachi are delivered as replacement parts. The Delphi generator is no longer produced. Converting generator, Delphi to Hitachi, refer to => [ Generator, Removing Delphi and Installing Hitachi ] Generator, Removing Delphi and Installing Hitachi.
• On generators with hard rubber disc clutch, this should generally be replaced with torsion-elastic clutch. Refer to => [ Generator with Torsion Elastic Clutch Overview ] Generator with Torsion Elastic Clutch Overview.
1 - Socket Head Bolt With Washer
• 8 Nm
• M6 x 20 mm
2 - Coolant Pipe/T-Piece
• Converting generator, Delphi to Hitachi, refer to => [ Generator, Removing Delphi and Installing Hitachi ] Generator, Removing Delphi and Installing Hitachi.
• Allocate according to parts catalog.
3 - O-ring
• Always replace
• Allocate according to parts catalog.
4 - Angle Bracket
5 - Bolts
• 20 Nm
• M8 x 35 mm
6 - Generator
• B+ wire fastener to generator, 15 Nm, refer to => [ B+ Cable Mount on Generator ] Procedures.
• Neither the voltage regulator nor the carbon brushes can be replaced individually; if a repair is required, the entire generator must be replaced.
• Generator, removing and installing, refer to => [ Generator with Torsion Elastic Clutch ] Generator with Torsion Elastic Clutch.
• One-way clutch at generator, removing and installing, refer to => [ Free-Wheel Belt Pulley ] Free-Wheel Belt Pulley.
• Converting generator, Delphi to Hitachi, refer to => [ Generator, Removing Delphi and Installing Hitachi ] Generator, Removing Delphi and Installing Hitachi.
7 - Torsion-Elastic Clutch
• Always replace
• Converting generator, Delphi to Hitachi, refer to => [ Generator, Removing Delphi and Installing Hitachi ] Generator, Removing Delphi and Installing Hitachi.
• Allocate according to parts catalog.
8 - Drive Gear
• Converting generator, Delphi to Hitachi, refer to => [ Generator, Removing Delphi and Installing Hitachi ] Generator, Removing Delphi and Installing Hitachi.
• Allocate according to parts catalog.
9 - Bolt
• 50 Nm + 90°
• M10 x 1 x 30 mm
• Converting generator, Delphi to Hitachi, refer to => [ Generator, Removing Delphi and Installing Hitachi ] Generator, Removing Delphi and Installing Hitachi.
• Allocate according to parts catalog.
10 - Alignment Bushings
• Check if alignment bushings are equipped and securely seated. If alignment bushings are loose, coat them with commercially available grease before installing.
11 - O-ring
• Allocate according to parts catalog.
• Always replace
12 - Coolant Pipe
• Converting generator, Delphi to Hitachi, refer to => [ Generator, Removing Delphi and Installing Hitachi ] Generator, Removing Delphi and Installing Hitachi.
• Allocate according to parts catalog.