Antitheft Motion Sensor: Service and Repair

Replacing the movement sensor

Replacing the front movement sensor

Removing the movement sensor




- Remove the soundproofing panel on the driver's side. See Dashboard Dashboard.




- Fold down the floor carpet. Remove the carpet bracket
- Remove the air duct for the rear seat.

Location Of Components, Alarm Components (Movement Sensor, Front):

- Disconnect the 5-pin connector (1).

Installing the movement sensor

Install:
In reverse order.
Program the control module. See Programming a new VGLA control module Programming a New VGLA Control Module.

Replacing the rear movement sensor

Removing the movement sensor

Remove:
- The seat cushion, backrest cushion and head restraint. See Rear seats Rear Seats.




- Insert a hand through the hatch for long loads. Unclip the movement sensor (3) mounted under the member (1)
- Disconnect the connector (2).

Installing the movement sensor

Install:
In reverse order.

Note! Insert the movement sensor into the mounting under the member. Slide it until a click is heard.

Program the control module. See Programming a new VGLA control module Programming a New VGLA Control Module.