Checking Cables

Checking Cables







- Ignition off.
- Disconnect VGLA control module. Check fuse 6.

Hint: If fuse 6 has blown, fault-trace the circuit after fuse 6 for a short-circuit to ground according to Checking wiring and terminals - Permanent faults, for further information about the circuit after the fuse, see the Wiring Diagrams.

Check circuit before fuse 6 for an open-circuit according to Checking wiring and terminals - Permanent faults. Check cable between fuse 6 and VGLA control module #B1 for an open-circuit according to Checking wiring and terminals - Permanent faults. Check cable between VGLA control module #A1 and ground for an open-circuit, according to Checking wiring and terminals - Permanent faults.

Checking Wiring and Terminals - Permanent Faults

Other information:
- The voltage between VGLA control module #B1 and ground should be battery voltage.

Remedy as necessary.

After performing this procedure Verification