Control Module HVAC: Service and Repair

Preparation:
Disconnect the battery ground cable
Drain engine coolant

1. Heater unit
^ Refer to "HEATER UNIT" removal procedure.
2. Case (Temperature control)
^ Remove the case (Temperature control) from the heater unit.
3. Rod
4. Sub-Lever
5. Door Lever
^ Pull out the door lever while raising up the catch of the door lever.
6. Clip

INSTALLATION
To install, follow the removal steps in the reverse order, noting the following points:
1. Apply grease to sub-lever and to the abrasive surface of the heater unit.
2. After installing the link unit, check to see if the link unit operates correctly.