System Specifications

TIGHTENING SPECIFICATIONS
Bearing Holder Mounting Nut 74 Nm (54 ft. lbs.)
Axle Shaft Runout (Limit) 1.0 mm (0.039 inch)
Inner Drive Pinion Bearing Nut 2.3 Nm (20 inch lbs.)
Bearing Caps 108 Nm (80 ft. lbs.)
Flange Nut 245-294 Nm (181-217 ft. lbs.)
Starting Torques:
New Bearing 0.7-1.3 Nm (6.08-11.28 inch lbs.)
Used Bearing 0.4-0.6 Nm (3.04-5.64 inch lbs.)
Ring Gear Backlash 0.15-0.2 mm (0.006-0.008 inch)
Ring Gear Runout :
Standard 0.02 mm (0.001 inch)
Limit 0.05 mm (0.002 inch)

Filler Plug Nut 7.8 Nm (58 inch lbs.)
Mounting Bracket:
Fixing Bolt 116 Nm (85 ft. lbs.)
Mounting Nut 152 Nm (112 ft. lbs.)
VSV Nuts 8 Nm (69 inch lbs.)
Protector Bolt 26 Nm (20 ft. lbs.)
Bracket Bolt 116 Nm (85 ft. lbs.)
Inner Shaft Run-out 0.5 mm (0.02 inch)
Axle Housing Bolt 116 Nm (85 ft. lbs.)
Shift Position Switch:
Bolt 39 Nm (29 ft. lbs.)
Actuator Bolt 13 Nm (156 inch lbs.)
Axle Shaft Bolt 116 Nm (85 ft. lbs.)