Windshield Wiper Motor Replacement

REMOVAL




Preparation: Disconnect the battery ground cable.

1. Windshield wiper motor
^ Disconnect the connector.
^ Remove four mounting bolts.
^ Remove the nut of the wiper motor shaft, and disconnect the linkage.

CAUTION:
To facilitate the removal of the nuts, be sure to put out the tip portion of the linkage sufficiently through the mounting hole of the motor by sliding the wiper blade slowly.

INSTALLATION
To install, follow the removal steps in the reverse order, noting the following points.
1. Tighten the wiper motor shaft nuts to the specified torque.

Nut torque N.m (lb.in) = 14 (122)

2. Remove the wiper arms on both sides, and rotate the wiper motor until it get to the auto-stop position to reinstall the wiper blade.