Removal and Installation
ALTERNATOR / REPLACEMENTNOTE: The original radio has a coded theft protection Circuit. Be sure to get the customer's code number before
- disconnecting the battery.
- removing the No. 47 (7.5 A) fuse from the under-hood fuse/relay box.
- removing the radio.
After service, reconnect power to the radio and turn it on. When the word "CODE" is displayed, enter the customer's 5-digit code to restore radio operation.
1. Disconnect the ground cable from the battery negative (-) terminal.
2. Disconnect the alternator connector from the alternator.
3. Remove the terminal nut and the WHT wire from the B terminal.
4. Loosen the adjusting nut, then remove the mounting nut.
5. Remove the alternator belt from the alternator pulley.
6. Remove the lower mounting bolt, then lift the alternator upward.
7. Remove the lower and upper mounting bracket bolts and the mounting brackets.
8. Remove the adjusting nut and upper mounting bolt, then lift out the alternator.
9. Install the alternator in the reverse order of removal.
CAUTION: Adjust the alternator belt tension after installation.
NOTE: Reconnect the battery ground cable and turn the radio on. When the word "CODE" is displayed, enter the customer's 5-digit code.