Cruise Control Switch: Testing and Inspection

CAUTION: Before disconnecting any part of an SRS wire harness, connect the short connectors.

SET/RESUME Switch Test:

1. Disconnect the cable reel harness and main harness 6P connector. Connect test harness C only to the cable reel harness side of the 6P connector.

SET/RESUME Switch Test:

2. Check for continuity between the terminals in each switch position according to the table.
^ If there is no continuity, check the cable reel.
^ If OK, go to step 3.

SET/RESUME Switch Test:

3. Remove the switch cover from the SET/RESUME switch, then remove the SET/RESUME switch by removing the two screws.

4. Check for continuity between the terminals in each switch position according to the tables.

SET/RESUME Switch Test:

If there is no continuity, replace the switch.