Cylinder Block Assembly

OIL: Lubricate all internal parts with engine oil during reassembly.

Lower Engine:

NOTE:
- Apply liquid gasket to the mating surfaces of the left side cover and oil pump case before installing them.
- Use liquid gasket, part No. 08718 - 0001 or 08718 - 0003.
- If the bottom of the oil pan is deformed, it should be repaired or the oil pan should be replaced retain proper clearance between the screen and the bottom.





OIL: Lubricate all internal parts with engine oil during reassembly.






NOTE: New rod bearings must be selected by matching connecting rod assembly and crankshaft identification markings.





CAUTION:
- The piston skirt is coated with molybdenum; handle the piston carefully to prevent any damage.
- The connecting rods are made of titanium. Attempting to remove the piston pin with conventional shop equipment will damage the connecting rod.
- If the piston, connecting rod, or piston pin require replacement, all three must be replaced as an assembly.