Power Mirror Motor: Service and Repair

Power Mirror Actuator Replacement

1. Remove the power mirror from the door.
2. Disconnect the connector(s) from the mirror.




3. Record the terminal locations and wire colors.
4. Cut the wire harness with wire cutter.
5. Remove the mirror holder.




6. Remove the three Torx screws using a Torx T10 bit, then remove the actuator (A).




7. Route the wire harness (A) of the new actuator through the hole in the bracket (B).







8. Insert the terminals into the connector as shown:
9. Seal the intersection of wire harness with tape.
10. Reassemble in the reverse order of disassembly. Be careful not to break the mirror when reinstalling it to the actuator.
11. Reinstall the mirror assembly onto the door.
12. Operate the power mirror to ensure smooth operation.