Power Seat Slide Position Sensor Troubleshooting
Power Seat Slide Position Sensor Troubleshooting1. Raise the driver's power seat up with the power seat up-down switch, then remove the power seat.
NOTE: Be careful no to scratch the interior trim.
2. Disconnect the power seat control unit connectors.
3. Disconnect the 4P connector from the slide position sensor.
4. Check for continuity between the No. 2 terminal of the slide position sensor and A11 terminal of the power seat control unit.
Is there continuity?
YES - Go to step 5.
NO - Repair open in the WHT/BLK wire.
5. Check for continuity between the No. 3 terminal of the slide position sensor and A2 terminal of the power seat control unit.
Is there continuity?
YES - Go to step 6.
NO - Repair open in the BLU/BLK wire.
6. Reconnect all connectors to run the seat motors.
7. Turn the ignition switch ON (II).
8. Check for voltage between the No. 4 terminal of the slide position sensor and body ground.
Is there about 5 V?
YES - Go to step 9.
NO - Repair open or short in the BRN wire.
9. Check for voltage pulse between the No. 3 terminal of the slide position sensor and body ground when the slide switch moves forward or backward.
Does voltage pulse from 0 to about 5 V alternately?
YES - Check for poor connections or loose terminals between the sensor and the driver's power seat control unit. If OK, replace the power seat control unit
NO - Check for a short in the wire. If the wire is OK, the slide position sensor is faulty; replace the slide motor assembly.