Utility Pocket Housing

Utility Pocket Housing Removal/Installation

Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program

NOTE:
- Put on gloves to protect your hands.
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
- Take care not to scratch the trim and panels.

1. Remove the center trim.




2. Remove the screws.




3. Gently pull out along the top of the utility pocket housing (A) to release the clips, then lower the front side down to release the pins (B) from the select lever bracket (C).




4. Disconnect the ambient light bulb socket (A), then remove the utility pocket housing (B).
5. Install the pocket housing in the reverse order of removal, and note these items:
- Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
- Make sure the bulb socket is connected securely.
- Push the clips into place securely.