MMS 300

Intake manifold assembly

Rules of cleanliness Service Precautions
Safety precautions Service Precautions

CAUTION! Seals must always be replaced.

Note: Check Diagnostic Trouble Code (DTC) memory and check functions using the output Diagnostic Test Mode(DTM) before starting repairs work on the fuel injection system.






1. Intake manifold upper section
2. 10 Nm (7 ft lb)
3. 20 Nm (15 ft lb)

4. Seal
Always replace

5. Idle Air Control (IAC) valve -N71-
6. 10 Nm (7 ft lb)
7. 6 Nm (53 in lb)
8. Flange
9. Intake manifold, lower section

10. Gasket
Always replace

11. 10 Nm (7 ft lb)
12. Vacuum unit
13. 20 Nm (15 ft lb)
14. Throttle Body (TB)

15. Gasket
Always replace

16. 20 Nm (15 ft lb)
17. EGR vacuum regulator solenoid valve

18. EGR temperature sensor-G98-
On intake manifold, lower section under throttle body

19. 10 Nm (7 ft lb)

20. Gasket
Always replace

21. 10 Nm (7 ft lb)