Coding A/C Control Head (Function 07)
NOTE: Always initiate "Basic Setting" function 04 after coding the A/C control head. Basic Setting (Function 04)Connect VAG1551 Scan Tool (ST) and VAG1551/1 adapter to Data Link Connectors (DLC) as follows:
- Remove cover from auxiliary relay panel 1 in plenum.
- Connect black connector to black DLC:
- Terminal 1 to: Ground (GND)
- Terminal 2 to: Battery positive voltage (B+) to VAG1551
- Connect white connector to white DLC.
- Blue connector is not used.
NOTE: If there is no display on the VAG1551 scan tool, check the B+ power supply to the black DLC. Data Link Connector (DLC) Wiring, Checking
Indicated on display (Operating modes 1 and 2 are displayed alternately):
V.A.G. - ON BOARD DIAGNOSTIC HELP
1 - Rapid data transfer
2 - Blink code output
- Switch ignition on.
- Press the "PRINT" button to switch on the scan tool printer (indicator lamp in button comes on).
- Press button -1- to select "Rapid data transfer" operating mode 1.
NOTE:
- Press the "HELP" button for additional information.
- Press the -> See button to advance the OBD program sequence.
Indicated on display:
Rapid data transfer HELP
Insert address word XX
Press buttons -0- and -8- to insert "AC/Heating Electronics" address word 08, and press -Q- button to confirm input.
If the display appears as shown:
Rapid data transfer HELP
Control module does not answer
Check DTC memory.
A/C control head identification and coding are displayed:
8A0820043 Klima-Vollautomat DXX ->
Coding 00062 WSC 23890
- A/C control head coding may be displayed with or without the 1st and 2nd digits (e.g. 062 instead of 00062), depending on the VAG1551 scan tool program card version.
- Replacement A/C control heads come with code "000" and must be coded after installation. After installation erase DTC memory and carry out basic setting.
- For correct part number and application.
A/C control head coding
1st and 2nd digits (where applicable)
Code Description
00_ _ _ Not used
3rd digit
Code Description
_ _0_ _ Not used
4th digit
Code Engine application
_ _ _6_ 6-cylinder
5th digit
Code Market version Engine type
_ _ _ _2 USA/Canada Gasoline
NOTE: "DXX" indicates the AA control head -E87- software version (e.g. DO1) and has no meaning for OBD.
Press -> button.
Indicated on display:
Rapid data transfer HELP
Select function XX
Press buttons -0- and -7- to select "Code Control Module" function 07.
Indicated on display:
Rapid data transfer Q
07 - Code Control Module
Press -Q- button to confirm input.
Indicated on display:
Code control module
Enter code number XXXXX (0-00127)
Using buttons on VAG1551 scan tool, enter coding for A/C control head according to A/C compressor type, engine cylinder configuration and market version. See Above.
EXAMPLE:
Coding Market version A/C compressor Engine
00062 USA/Canada Zexel 6-cyl. gasoline
Press -Q- button to confirm input.
Indicated on display (A/C control head identification, coding):
8A0 820 043A Klima-Vollautomat DXX ->
Coding 00062 WSC 23890
Press -> button.
Indicated on display:
Rapid data transfer HELP
Select function XX
- Initiate basic setting. Basic Setting (Function 04)
- Check DTC memory. Checking and Erasing DTC Memory