A-Disconnecting Retractor Cable at Retractor Cable Tube

- Remove sill panel trim.
- Remove lower A-pillar trim.
- Move carpet in front seat area to side.

1 - Cap
- Leads to engine compartment
2 - Retractor cable tube
To disconnect retractor cable:
- Remove self-tapping screw -7-
- Unhook cap -1-
- Lift spring lugs (arrows)
- Pull cap -6- off retractor cable tube -2-
- Lift spring lugs using flat screwdriver
- Slide locking cap -3- off coupling -4-
- Remove nipple -5- from coupling -4-
3 - Locking cap
4 - Coupling
5 - Nipple
6 - Cap
- Leads to front three-point seat belt retractor
7 - Self-tapping screw
- 2 Nm (18 in. lb)