Cylinder Head Tightening Sequence & Torque

Cylinder head bolt tightening and torque sequence

Notes: Bolt holes in engine block for cylinder head bolts must be free of oil and coolant.
Always replace cylinder head bolts.






Tighten cylinder head bolts in two stages in sequence shown, as follows:
Stage 1: 60 Nm (44 ft. lbs.)
Stage 2: additional 1/2 turn (180°) using rigid wrench (in two 1/4 turns (90° if necessary).

It is not necessary to re-torque cylinder head bolts again after repairs have been completed.