ATF, Draining For ATF Flushing Process

ATF, draining for ATF flushing process - 01J, Continuously Variable Transmission (CVT)
^ Vehicle on a flat surface

Note:
^ Observe disposal regulations!
^ Activate vehicle lifting mode before driving vehicle with air suspension onto hoist, that is, with all four wheels hanging.





- Loosen fasteners - 2 - and - 3 - and remove rear noise insulation - B -.

- Place an oil receptacle underneath transmission.





- Remove ATF drain plug - A - using triple square socket driver 3357 and drain ATF.

- Tighten ATF drain plug again.

^ Tightening torque: 24 Nm.

CAUTION!
Do not allow engine to run without filling ATF and do not tow the vehicle.