Tire Pressure Monitoring Control Module

Coding Tire Pressure Monitoring Control Module (J502)

If tire pressure monitoring control module is replaced, new control module must be coded. To do this, proceed as follows.

- Connect (VAS 5051B) and then perform vehicle-specific entry into Guided Fault Finding and select Go To button "function/component selection". Refer to => [ VAS 5051B, Connecting and Selecting Functions ] .

Then:

- "Chassis (Repair group 01; 40 - 49)"

- "Tire pressure monitoring (Repair group 01; 44)"

- "01- On Board Diagnostic (OBD) capable systems"

- "65 - Base Low Tire Pressure Monitoring Control Module" or "65 - High Tire Pressure Monitoring Control Module Sensor"

- "J502 - Tire Pressure Monitoring Control Module, functions"

- "J502 - Code control module"