All Wheel Drive

Rear Axle ABS Component Overview





1 - Rear brake caliper

• Removing and installing, refer to => [ Brake Caliper Assembly Overview, C38 ] Brake Caliper Assembly Overview, C38.

2 - Wheel hub

• Removing and installing, refer to => Suspension Suspension

3 - Collar bolt

Vehicle must be resting on the ground when tightening.

• Always replace.

• For tightening specification, refer to => Suspension Suspension

4 - Brake rotor

• Always replace both sides.

• Remove the brake caliper prior to removing.

• Thickness, refer to => [ Rear Brake Specifications ] Rear Brake Specifications.

• Allocation, refer to => [ Rear Brake Specifications ] Rear Brake Specifications.

5 - Wheel bolt

Vehicle must be resting on the ground when tightening

• Installing the wheels, refer to => Steering and Suspension Steering and Suspension

6 - Wheel bearing

• Removing and installing, refer to => Suspension Suspension

7 - Wheel bearing housing

• Removing and installing, refer to => Suspension Suspension

8 - Wheels speed sensor

• Left and right sensors are identical.

• Removing and installing, refer to => [ Rear Wheel Speed Sensor ] Rear Wheel Speed Sensor.

• Before inserting into the wheel bearing housing, lubricate the circumference with lubricating paste (G 000 650)

• Press into the wheel bearing housing onto the stop.

• Release speed sensor connector and disconnect. Unclip speed sensor wiring.

9 - Hex head bolt

• Tightening specification: 10 Nm.

10 - Drive axle

• Check the rotor for contamination and damage.

• If the rotor is damaged, replace the outer Constant Velocity (CV) joint.

• The outer CV joint is delivered as a replacement part with rotor

11 - Ribbed bolt, 75 Nm

• Always replace.