Directional Stabilization Assistance Control Module and Lens Screen

Directional Stabilization Assistance Control Module and Lens Screen

Removing






- Remove the cover trim - 1 - down from the bracket in the direction of the arrow.

- Press the retaining clamp - 1 - forward in the - direction of the arrow - and remove the directional stabilization assistance control module (J759) sideways and down from the bracket.






- Disconnect the electrical connector and remove the directional stabilization assistance control module.

- Press the clamps - arrows -, pull the lens screen out of the bracket and remove it toward the rear.






Installing

Install in reverse order of removal. Note the following:

• The camera visual area on the inside of the window must not be covered with condensation or dirty. If it is, clean the visual window by hand using a cleaning solution (D 009 401 04).

• If the directional stabilization assistance control module was replaced, then the camera and the directional stabilization assistance control module must be calibrated. Refer to => [ Lane Assist Calibration Procedure ] Lane Assist Calibration Procedure.