Operation CHARM: Car repair manuals for everyone.
Home >> Audi >> 2011 >> A6 Sedan (4F2) V6-3.2L (CALA) >> Repair and Diagnosis >> Power and Ground Distribution >> Service and Repair >> Removal and Replacement >> Table of Contents >> Relay Carrier, General Information >> Relay and fuse panel behind instrument panel, driver's side, removing and installing
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Relay and fuse panel behind instrument panel, driver's side, removing and installing







Relay and fuse panel behind instrument panel, driver's side, removing and installing

Removing





- With ignition switched off, disconnect battery Ground (ND) wire => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Remove lower instrument panel cover on driver's side.

- Remove nuts - arrows - and remove Vehicle Electrical System Control Module (J519) - item 2 - with wires connected.

- Remove relay and fuse panel - 1 -.

If necessary, proceed with work steps.

- Unclip fuse panel at relay and fuse panel.

- Disconnect relays and unclip respective relay carrier.

• For the exact assignment of the relay and fuse panel behind instrument panel on driver's side, refer to the current wiring diagram.

Installing

Install in reverse order of removal, observing the following:

- Install lower instrument panel cover on driver's side.

- Connect battery. Required actions => [ Vehicles with : ] Battery, Disconnecting and Connecting.

Tightening Specifications




pro multis · About Operation CHARM