Procedures

Removing And Installing/Replacing Ignition Starter Switch

Necessary preliminary tasks:
- Move ignition lock to key position 0 (stop)
- Remove lower section of steering column trim







IMPORTANT:
Before removing ignition starter switch (1), secure inner shaft against turning:
Insert a M2.5*8 screw in bore (2).

Installation:
Remove screw in bore (2).







Release screws (1),
Tightening Torque
1AZ Ignition starter switch 0.4 Nm

Installation:
Secure screws (1) with sealing paint.

IMPORTANT:
The ribbon cable must be replaced once the ribbon cable plug connection has been disconnected.
The ribbon cable leads to the control unit for the Car Access System.

Disconnect associated plug connections and remove ignition starter switch (2).