25 11 245 Replacing Shift Arm Support Bearing

25 11 245 - Replacing shift arm support bearing





Necessary preliminary tasks:
- If necessary, remove reinforcement carrier.
- Remove rear underbody protection Removing and Installing/Replacing Rear Underbody Protection.
- If necessary, release middle heat shield, do not remove.





Note:
Only if heat shield has to be released.

Release nut (1) and remove bracket from rear differential.

Slide heat shield towards rear.





Lever support bearing (1) with a short screwdriver out of mounting.
Pull support off shift arm.






Installation Note:
Grease bearing pin of shift arm.
Fit support bearing (1) with opening (2) towards top rear onto mounting.