Operation CHARM: Car repair manuals for everyone.
Home >> Buick >> 2000 >> Regal V6-3.8L SC VIN 1 >> Repair and Diagnosis >> Brakes and Traction Control >> Hydraulic System >> Hydraulic Control Assembly - Antilock Brakes >> Service and Repair >> Brake Modulator Bracket Replacement
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Brake Modulator Bracket Replacement

Removal Procedure
1. Turn the Ignition switch to the OFF position.





2. Remove the two BPMV mounting bracket nuts (3) and one bolt located near the bottom and one nut (1) located at the top of the BPMV mounting bracket (4) to the strut tower.
3. Disconnect the ground strap between the EBCM assembly and the chassis.
4. Remove the BPMV mounting bracket (4) from the vehicle.
5. Remove BPMV and EBCM assembly (2) from the BPMV mounting bracket (4).

Installation Procedure





1. Install the BPMV and EBCM assembly (2) to the BPMV mounting bracket (4).
2. Install the BPMV bracket (4) to the strut tower.
3. Install the one bolt and three nuts that attach the BPMV mounting bracket (4) to the strut tower.
^ Tighten the lower two BPMV mounting bracket nuts (3) and bolt to 10 Nm (7 lb. ft.).
^ Tighten the top nut (1) for BPMV mounting bracket (4) to strut tower to 3 Nm (26 inch lbs.).

4. Reconnect the ground strap between the EBCM assembly and the chassis.
5. Turn the ignition switch to the RUN position, engine off.
6. Perform the A Diagnostic System Check-ABS.
pro multis · About Operation CHARM