Accelerator Pedal: Service and Repair

REMOVAL PROCEDURE
1. Remove the left instrument panel sound insulator.
2. Disconnect the accelerator cable (5) from the accelerator pedal (1).
3. Remove the bolts (3) and studs (2) holding the accelerator pedal to the bulk head (4).
4. Remove the accelerator pedal.

INSTALLATION PROCEDURE

IMPORTANT: The throttle should operate freely without binding between a full Closed and a Wide Open Throttle.

1. Position the accelerator pedal (1) to the bulkhead (4).

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the accelerator pedal bolts (3) and the studs (2).

Tighten
Tighten the accelerator pedal assembly bolts and studs to 3.0 N.m (27 lb in).

3. Connect the accelerator cable (5) to the accelerator pedal (1).
4. Install the left instrument panel sound insulator.
5. Check for complete throttle opening and closing positions by operating the accelerator pedal. Also, check for poor carpet fit under the accelerator pedal.