Ignition Control Module: Service and Repair

REMOVAL PROCEDURE
1. Turn the ignition OFF.
2. Disconnect the 14-way connector from the ignition control module.
3. Disconnect the spark plug wires from the coil assemblies. Nothing the position that they were removed.
4. Remove 6 screws (1) securing the coil assemblies to the ignition control module.
5. Remove the coils (2) from the ignition control module (3).
6. Remove the nuts and washers securing the ignition control module assembly to the mounting bracket.
7. Remove the ignition control module from the module bracket.

INSTALLATION PROCEDURE
1. Attach the coils (2) and the ignition control module (3) to the module bracket. Refer to ignition Coil(s) Replacement

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install 6 ignition coil attaching screws (1).

Tighten:
Tighten the screws to 4-5 N.m (40 lb in).

3. Install the nuts and washers securing the ignition control module assembly to the mounting bracket.

Tighten:
Tighten the nuts to 8 N.m (70 lb in).

4. Connect the spark plug wires.
5. Connect the 14-way connector to the module.