HVAC Control Module

HVAC CONTROL MODULE REPLACEMENT

REMOVAL PROCEDURE





1. Remove the I/P accessory trim plate.
2. Remove the HVAC control module screws.
3. Depress the HVAC control module tabs (3) and remove the HVAC control module (2) from the I/P (4).
4. Disconnect the electrical connectors (1) from the HVAC control module (2).

INSTALLATION PROCEDURE





1. Connect the electrical connectors (1) to the HVAC control module (2).
2. Install the HVAC control module (2) into the I/P (4).

IMPORTANT: Ensure that the HVAC control module tabs (3) lock into place.

3. Install the HVAC control module screws.

Tighten the screws to 1.9 N.m (17 lb in).

NOTE: Refer to Fastener Notice.

4. Install the I/P accessory trim plate.
5. Refer to Control Module References for programming and setup information. Programming and Relearning