Front Wipers

1. CHECK condition of FRT WIPER (Fuse 11). If Fuse is open, LOCATE and REPAIR source of overload. REPLACE Fuse.
2. CHECK for proper mechanical operation. REPAIR binding linkage prior to electrical diagnosis.
3. Ensure Washer Fluid Reservoir is full before proceeding if you are Checking Washers operation.
^ CHECK for a broken (or partially broken) wire inside of the insulation which could cause system malfunction but prove GOOD in a Continuity/Voltage check with a system disconnected. These Circuits may be intermittent or resistive when loaded, and if possible, should be checked by monitoring for a voltage drop with the system operational (under load).
^ CHECK for proper installation of aftermarket electronic equipment which may affect the integrity of other systems.